Product Features:
1, can be wet base surface construction.
2, can be used for the positive side and negative surface water.
3, water resistance, moisture resistance, excellent resistance to aging.
4, strong paste, slurry of cement-based active ingredients can penetrate the surface of the pores, and micro-cracks within the surface layer of dense polymer waterproof membrane.
5, the slurry dries without protective layer of mortar to do direct follow-up process.
6, non-toxic, harmless and environment-friendly products.

Base surface treatment:
1, the base surface to be strong and smooth, clean, no oil, no concrete release agent thereon.
2, the yin and yang, rounded corners make suggestions or diamond.
3, the base oil for a surface application of 10% sodium hydroxide solution to scrub, then rinse with water.
4, for hollowing, loose base surface, tip off the projections should be used to eradicate and polymers (interface treatment agent) to repair the cement mortar.

Construction process:
1, in the dry surface of the base construction should be preceded by wet-based waterproof coating surface water subject to ignorance, if the base surface moist but not that water can be directly repaired.
2, according to the product mix, the first emulsion into water and spices in mixing bucket, after adding the powder using electric blender to mix evenly, let it rest 10 minutes and then stir until the mortar until the powder-free.
3, using brush or roller brushing the paste evenly on the base surface of the plasma, if the bubbles when brushing, brushing the gas discharge should be repeated, and careful not to leave any brush or leakage defects.
4, the first cream finish brushing should wait until dry solid pulp (about 2 hours), then brushing the second slurry paste, the first and the second should be perpendicular to the direction of brushing.
5, After 24 hours the waterproof layer dry completely before entering the construction of other solid cover.

Note:
1, the air humid, poorly ventilated areas, ventilation should be used to speed up the waterproof coating film, for example, sealed drinking water tank or basement.
2, the completed waterproofing layer in the absence of the protective layer before, without iron, nails, steel scaffolding with water chestnut in a waterproof layer of heavy construction or stacked, so as not to damage the waterproof layer.
3, is strictly prohibited to wear high heels or shoes with a small construction site into the waterproof layer, so as not to damage the waterproof layer.
4, cream pulp in the construction process should be maintained intermittent stirring to avoid precipitation.
5, is strictly prohibited on rainy days or at 5 ℃ -40 ℃ environment outside of the construction.

Storage:
Store in a cool dry place, unopened powder can be stored for 12 months.

Use area: 18 ~ 22M² / set (a powder containing 9KG pulp +25 KG)